rusEFI project¶
Fuel¶
Fuel short-term closed-loop correction
Intake air temperature fuel Multiplier
Acceleration or Deceleration Enrichment
Engine Load Acceleration Enrichment Taper
Injection settings¶
Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection
Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection
Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection
Injector dead time¶
Fuel short-term closed-loop correction¶
Coasting Fuel Cutoff Settings¶
Enable Coasting Fuel Cutoff: This setting disables fuel injection while the engine is in overrun, this is useful as a fuel saving measure and to prevent back firing.
TPS Deactivation Threshold(%): percent between 0 and 100 below which the fuel cut is deactivated, this helps low speed drivability.
Fuel Table¶
Injection Phase¶
Warmup fuel manual Multiplier¶
Intake air temperature fuel Multiplier¶
tCharge Settings¶
Acceleration or Deceleration Enrichment¶
TPS Acceleration Extra Fuel¶
Engine Load Acceleration Enrichment Taper¶
generated by class com.rusefi.MdGenerator on Fri May 01 15:24:28 EDT 2020