Debug Fields

Debug fields is an advanced troubleshooting feature allowing one to monitor internal state of some rusEFI subsystems. In an ideal world we would be always saving all these data points, in reality we need to only save those while troubleshooting something specific.

set debug_mode CODE

code name debug f1 debug f2 debug f3 debug f4 debug f5 debug f6 debug f7 debug i1 debug i2 debug i3 debug i4 debug i5
0 Alternator_PID controller output integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
1 TPS acceleration from TPS to TPS current TPS<>TPS value extra fuel
2 Warmup PID 3 Idle controller output integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
4 Engine load acceleration
5 Trigger Counters channel #1 rise counter channel #2 rise counter channel #3 rise counter channel #1 fall counter channel #2 fall counter channel #3 fall counter
6 FSIO ADC
7 Aux PID #1 controller output integration term previous error I setting D setting dTerm
8 VVT position VVT event counter
9 Cranking cycles from start counter
11 short-term closed loop fuel PID integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
12 VSS vss event counter
17 ETB electronic throttle body PID duty cycle integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
21 ADC #1 / Analog Inputs VBatt TPS MAF MAP CLT IAT EGO
23 FSIO_EXPRESSION FSIO output #1 FSIO output #2 FSIO output #3 FSIO output #4 FSIO output #5 FSIO output #6
24 Status Seconds since reboot VCS_VERSION
25 CJ125 Heater Duty Heater PID I Term Heater PID Err UA UR Calibr.UA Calibr.UR State Diag.reg
26 CAN read counter write OK write NOT ok
31 TLE8888 SPI counter latest transmit latest recieved init count (should be 2) i5

Base Engine Settings

Debug Gauges