rusEFI project

Fuel

Injection settings

Injector dead time

Fuel short-term closed-loop correction

Coasting Fuel Cutoff Settings

Fuel Table

Injection Phase

Warmup fuel manual Multiplier

Intake air temperature fuel Multiplier

tCharge Settings

Accel/Decel Enrichment

TPS/TPS Acceleration Extra Fuel(ms)

Engine Load Acceleration Enrichment Taper

Injection settings

x

Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection

Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection

Two wire batch emulation: This is needed if your coils are individually wired and you wish to use batch injection. enable two_wire_batch_injection

Injector dead time

x

Fuel short-term closed-loop correction

x

Coasting Fuel Cutoff Settings

x

Enable Coasting Fuel Cutoff: This setting disables fuel injection while the engine is in overrun, this is useful as a fuel saving measure and to prevent back firing.

TPS Deactivation Threshold(%): percent between 0 and 100 below which the fuel cut is deactivated, this helps low speed drivability.

Fuel Table

x

Injection Phase

x

Warmup fuel manual Multiplier

x

Intake air temperature fuel Multiplier

x

tCharge Settings

x

Accel/Decel Enrichment

x

TPS/TPS Acceleration Extra Fuel(ms)

x

Engine Load Acceleration Enrichment Taper

x

generated by class com.rusefi.MdGenerator on Fri May 01 15:24:28 EDT 2020